Elm Grove, WI HVAC, Plumbing & Electrical Services
Elm Grove is a 3.3-square-mile village of about 6,400 residents incorporated in 1955, with zoning that has held lot sizes large and tree cover dense since the start. Homes along Watertown Plank Road, Juneau Boulevard, Legion Drive, and the streets surrounding the former School Sisters of Notre Dame campus routinely run 3,000 to 5,000 square feet on half-acre and larger parcels. Median household income sits around $133,000 and the homeownership rate is over 88 percent — the practical effect is that the mechanical equipment we work on in Elm Grove tends to be higher capacity, multi-zone, and more integrated than in surrounding suburbs.
Burkhardt Heating, Cooling, Plumbing & Electric reaches Elm Grove from our Brookfield location on N. Calhoun Road — one of the shortest response zones in our entire service area. The village has been part of our standing service territory since the company was founded in 1961, and our technicians know the streets and the equipment by name.
The housing stock spans roughly a century. Tudors and colonials from the 1920s and 1930s along Watertown Plank Road and near Juneau Boulevard still run hot-water radiator systems in some cases. Post-war ranches and customs from the 1950s and 1960s sit on the larger lots that define the village. Newer construction on the former School Sisters parcel (now Caroline Heights) adds modern high-performance homes to the mix, with the School Sisters of Notre Dame having moved to Trinity Woods on the Mount Mary campus after 162 years in Elm Grove. Each era brings its own mechanical service profile, and the same Elm Grove home can carry equipment from three or four different decades stacked together. To schedule, call (414) 206-3049.
Services Available in Elm Grove
Heating and cooling. Few neighborhoods we serve carry as much equipment variety as Elm Grove. Period homes near Watertown Plank Road sometimes still run gravity-converted forced-air or original hot-water boilers feeding cast iron radiators. Every boiler tune-up we perform includes checking water pH and hardness, then treating with inhibitor as needed — Wisconsin's well water and older municipal lines can corrode heat exchangers and cake up boiler internals, shortening system life by years if left unchecked. Mid-century customs run zoned forced-air, often with two furnaces and two condensers for the home's footprint. Newer construction layers in variable-speed equipment, whole-home humidification and air filtration, and hydronic radiant floors. Heat pump retrofits are growing in the larger homes where two-stage gas plus heat-pump backup makes sense for the loads.
- AC Repair
- Furnace Repair
- Boiler Repair — see our boiler resource
- Ductless mini-split installation — reference the ductless guide
Common HVAC issues we see in Elm Grove:
- Radiator banging and short-cycling in pre-WWII homes
- Second-floor comfort gaps in 4,000+ square foot homes with single-zone systems
- Variable-speed and zoning control board failures on newer multi-stage equipment
Plumbing. Elm Grove is on municipal water with Waukesha County hardness, so softener service and sizing are routine work for our plumbing team. Large homes typically run two water heaters or a 75- to 100-gallon tank to support multiple bathrooms and high-flow fixtures, and recovery rate — not just tank size — drives the sizing conversation, particularly on homes with luxury showers and soaking tubs. Older homes near Juneau Boulevard and Watertown Plank Road occasionally retain galvanized supply, which we still address on a regular basis. Sump pump capacity is a routine consideration on the larger lots where roof and downspout volume strains undersized systems.
- Emergency Plumber (weekday hours)
- Drain Cleaning — reference the drain cleaning guide
- Water Heater Repair — see the water heater pillar
Common plumbing issues we see in Elm Grove:
- Insufficient hot water recovery in homes with three or more bathrooms on a single tank
- Galvanized supply line corrosion in pre-1955 homes
- Sump pump capacity on the larger lots where roof and downspout volume strains the system
Electrical. Elm Grove homes routinely run 200-amp service, and 400-amp upgrades are increasingly common as EV chargers, whole-home generators, electric appliance upgrades, and heat pump retrofits stack up on the same panel. Estate homes with detached garages, pool equipment, irrigation controllers, landscape lighting, and outbuildings carry electrical work that goes well beyond a basic residential scope. We coordinate the We Energies service entrance upgrade and pull permits with the Village of Elm Grove as part of larger service jobs.
- Electrical Repair
- 400-amp service upgrades, generator installs, Level 2 EV charging
Common electrical issues we see in Elm Grove:
- Older 200-amp panels reaching capacity with modern loads
- Whole-home standby generator installs with automatic transfer switches
- Level 2 EV charger installs paired with panel and service upgrades
Furnace Tune-Ups in Elm Grove
Two thirds of Elm Grove's homes were built before 1970, and ranch homes are the most common type in the village. Many have ductwork that runs through an attic or crawl space, and furnaces that have been in place for a long time.
A tune-up covers the burners, flame sensor and ignitor, the heat exchanger, safety controls, venting, a carbon monoxide test, and the filter and blower. We also note the condition of exposed ductwork, since leaks and missing insulation in an attic run cost heat every hour the furnace operates.
Tune-ups are included in the Burkhardt Signature Club. To schedule one in Elm Grove, call 414-206-3049.
More on this service: Furnace tune-up.
Heat Pump Systems in Elm Grove
Elm Grove homes are mostly ranches, colonials and Cape Cods from the 1940s through the 1960s, and many are due for new heating and cooling equipment at the same time. That is the natural point to consider a heat pump in place of a standard air conditioner, paired with a new or existing gas furnace.
The village also has a notable number of homes with hot water radiators and no ducts. For those, ductless heat pumps provide air conditioning and efficient heating room by room, and the boiler stays in place for the coldest weather.
Whichever type fits, we check the ductwork or plan the indoor unit locations, review the electrical panel, and size the system to the house. We install Armstrong, Concord and other brands and service all major manufacturers. Consultations are free. Call 414-206-3049.
More on this service: Heat pump installation.
Boiler Installation and Replacement in Elm Grove
Elm Grove's oldest homes, the Tudors and colonials from the 1920s and 1930s, were built with boilers and radiators, and a number of mid-century custom homes in the village heat with hot water as well. Many of those systems still run on cast-iron boilers that are decades old.
When one is due for replacement, we start with a heat loss calculation for the house. Older boilers were commonly oversized, and a correctly sized high-efficiency boiler runs longer, quieter and on less gas. We keep the radiators or baseboard that are in good condition, and replace the circulators, expansion tank, valves and controls that are not.
Homes with original radiators stay comfortable with a new boiler, and there is no need to convert to forced air to get modern efficiency. Boiler replacement consultations are free. Call 414-206-3049.
More on this service: Boiler installation.
AC Installation and Replacement in Elm Grove
Replacing an air conditioner in Elm Grove usually means looking past the outdoor unit. Many homes here are ranches with ductwork in the attic or a crawl space, where cooled air picks up heat before it reaches the rooms. Sealing and insulating those runs can matter as much as the new equipment.
Homes on the village's large wooded lots are often 3,000 square feet or more, and shade from mature trees lowers the cooling load on some sides of the house and not others. We run a load calculation room by room instead of sizing from square footage, and we recommend zoning or a second system where one air conditioner cannot serve the whole house evenly.
We install Armstrong, Concord and other brands. Replacement consultations are free, and financing is available through GreenSky. Call 414-206-3049.
More on this service: AC installation.
AC Repair and Service in Elm Grove
Burkhardt repairs and services air conditioners in Elm Grove from our Brookfield location next door. We work on all major brands of central air and ductless systems.
In the older Tudors and colonials near the village center, central air was fitted to duct layouts designed for an earlier kind of heating. Those systems tend to have weak airflow: return grilles that are too small, and ducts through hot attic space that lose cooling before it reaches the bedrooms. A repair visit there often includes an airflow check, because a part that fails repeatedly is frequently a symptom.
The repairs themselves are familiar: capacitors, contactors, fan motors, refrigerant leaks, frozen coils and blocked condensate drains. Same-day repair and 24-hour emergency cooling repair are available. Call 414-206-3049.
More on this service: AC repair.
Explore Our Services
Why Elm Grove Homeowners Choose Burkhardt
- Family-owned and serving the Milwaukee metro since 1961, with Elm Grove in our standing service area throughout
- Brookfield location at 405 N Calhoun Road is close to Elm Grove — one of our shortest response zones
- Service technicians experienced with hot-water radiator systems, multi-zone forced-air, geothermal, and hydronic radiant floor equipment
- Google Guaranteed and BBB-accredited — not a franchise or national chain, and not a private-equity rollup of smaller shop
- HVAC, plumbing, and electrical under one roof, which matters on whole-home projects in estate-class housing where multiple trades hit the same project at the same time
Elm Grove's proximity to our Brookfield shop means weekday non-emergency appointments are typically same-day or next-business-day outside the spring AC and fall furnace peaks, when regional wait times stretch to two or three weeks. After-hours and Saturday coverage applies to heating and cooling emergencies through our on-call rotation. Non-emergency plumbing and electrical work runs Monday through Friday, 7 a.m. to 5 p.m. Equipment replacement quotes are written and provided before any work is scheduled, and GreenSky financing with multiple term options is available on qualifying projects. To schedule, call (414) 206-3049 or book online.



.webp)






.webp)